As a result, viscosity measurements are always reported with the temperature at which the measurement is made. As temperature increases, the viscosity will decrease. Viscosity is influenced by the composition of the crude oil, the temperature, dissolved gas content, and the pressure. For a frame of reference, the viscosity of some common materials is as follows: water в€ј1В cP, olive oil в€ј80В cP, honey 2000вЂ“10,000В cP, peanut butter в€ј250,000В cP, and chocolate в€ј1,000,000В cP. It is measured in poise (P), 0.100В kgВ m в€’1В s в€’1, but usually expressed as centipoise (cP), 0.001В kgВ m в€’1В s в€’1. Viscosity is the internal friction due to molecular cohesion in fluids which results in resistance to flow. Harry Dembicki, Jr., in Practical Petroleum Geochemistry for Exploration and Production, 2017 Viscosity This is because their average molecular weight can be adjusted to a value closer to the critical limit for shear stability. Consequently, at a given stability level and structure, VI improvers with a narrower molecular-weight distribution will have a higher thickening power. It should be noted that because shear stability is molecular weight sensitive, the molecular weight of a VI improver with a broad distribution will have to be adjusted to a comparatively low value for proper control of SSI. In Figure 41 311 it is clear that the star polymethacrylate (PMA) VM behaves better than the linear PMA or PIB because it has the highest VI with a minimum SSI. 309 Under the same shear rate their higher viscosity 310 is the reason why star polymers are used as an improved VI in the multigrade lubricating oils. Toward these lines star polymers (e.g., star polymethacrylates, hydrogenated star PIs) are perfectly suited for VI improvers, as they have higher shear stability than the corresponding linear ones. The lower the value of SSI, the better or more resistant is the VI improver to mechanical stress or shear. Shear stability of VI (or VM) is evaluated by determining the shear stability index (SSI), which is a measure of loss of viscosity due to shearing.

Lower-molecular-weight polymers are more shear resistant but do not improve viscosity as effectively as at higher temperatures and, therefore, must be used in larger quantities. Higher-molecular-weight polymers make better thickeners but tend to have less resistance to mechanical shear.

As the additive (VI improver) is repeatedly sheared in the engine, it loses its ability to act as a more viscous fluid at higher temperatures, due to chain scission.

The word viscous comes from the Latin root viscum, meaning sticky.The primary disadvantage of the polymers as VI is their sensitivity (chain scission) to mechanical shearing. If the lava is thin (low viscosity), then it just flows out like water. This is because the lava has a hard time getting out and may burst out when it can.

When the lava comes out very thickly ( viscous), there is more chance that it will erupt violently. Viscosity is used as a way to predict when volcanoes erupt. There are two types of viscosity: dynamic viscosity, measured in pascal seconds, and kinematic viscosity, measured in metres per second squared. Syrup would reach the bottom very slowly, and water would be much quicker. A way to test for viscosity is the speed at which the substance runs down a slope. Syrup and tar, on the other hand, have a high viscosity, as they are 'thick'. In a simple example, water has a low viscosity, as it is 'thin'. Viscosity is a physical property of fluids. Illustration of viscosity the violet fluid at the bottom has a higher viscosity than the clear one above

Define viscosity